Description
DB Drive WDX8G2R.2 8-Inch Dual 2-Ohm Subwoofer
Need a serious 8-inch subwoofer, not just a small woofer because the enclosure space is tight? That is where the WDX8G2R.2 makes sense. DB Drive rates it at 750 watts nominal and 1500 watts dynamic, with a high-excursion motor using Y35 ferrite magnets, reinforced suspension, and a 2.5-inch high-temperature voice coil. This is built to take real amplifier power and work in a proper subwoofer enclosure.
The dual 2-ohm voice coils are the system-design part that matters. One sub can be wired to a 1-ohm or 4-ohm final load, so it gives us a clean way to match a monoblock that makes its rated power at 1 ohm without needing a second sub just to get the impedance where we want it. That makes this version different from a dual-4-ohm model even though the cone size is the same.
The die-cast aluminum vented basket, double-stitched foam surround, and dual poly-cotton dampeners are all there to keep the moving assembly controlled when excursion goes up. DB Drive also uses large-gauge compression terminals and a rubber gasket trim ring, so the mechanical side of the install is built around a rigid mount and a good enclosure seal.
It is still a physically substantial 8-inch subwoofer. DB Drive publishes an 8.78-inch outside diameter, 7.36-inch cutout, 5.55-inch mounting depth, and 0.08 ft³ of woofer displacement. Those numbers need to be accounted for when we calculate net enclosure volume and verify motor clearance behind the baffle.
What it will not do: this is not a shallow-mount 8-inch subwoofer. A single dual-2-ohm sub also cannot be wired to 2 ohms by itself; if the amplifier needs a 2-ohm load from one woofer, a different voice-coil configuration makes more sense.
Manufacturer Construction
- 2.5-inch anodized-aluminum high-temperature voice coil
- Non-pressed paper cone
- Double-stitched reinforced foam surround
- Dual poly-cotton dampeners
- High-excursion motor with Y35 ferrite magnets
- Die-cast aluminum vented basket
- Rubber gasket trim ring
- Large-gauge compression terminals
- Protective magnet cover
Manufacturer Specifications
- Dynamic power handling: 1500 watts
- Nominal power handling: 750 watts
- Impedance: dual 2-ohm voice coils
- DC voice-coil resistance (Re): 2 × 2 ohms
- Resonant frequency (Fs): 37.64 Hz
- Mechanical quality factor (Qms): 3.44
- Electrical quality factor (Qes): 0.73
- Total quality factor (Qts): 0.60
- Equivalent air volume (Vas): 6.47 L
- Mechanical compliance (Cms): 112.636 mm/N
- Moving mass (Mms): 158.77 g
- Force factor (BL): 14.38
- Sensitivity: 78.6 dB
- Outside diameter: 8.78 inches / 223 mm
- Cutout diameter: 7.36 inches / 187.5 mm
- Mounting depth: 5.55 inches / 141 mm
- Woofer displacement: 0.08 ft³
Final Inventory
Remaining SMS Car Audio inventory. This item is new/unused unless otherwise stated on the listing. Quantity is limited and will not be restocked. Contact SMS Car Audio for final inventory pricing and current availability. Final sale.
Where this fits in the build
The subwoofer is only one part of the bass system. Enclosure volume and alignment, final impedance, amplifier power, vehicle space and electrical support all affect the result.










