Description
LASFIT LO-JPS01 Jeep Wrangler JL / Gladiator JT Auxiliary Switch Panel
Adding lights and other 12-volt accessories to a Wrangler JL or Gladiator JT and tired of hanging universal toggle switches under the dash? That is what the LO-JPS01 is for. LASFIT gives you four OEM-style auxiliary switches in the factory-style dash location, along with the relay and fuse hardware needed to control the accessory circuits without requiring a dealer software flash.
The four switches run through a waterproof relay/fuse box with four 30-amp fused relay circuits. LASFIT provides connection points inside the cabin and in the engine compartment, which gives us cleaner options for routing accessory wiring depending on where the equipment is installed. Those two connection locations share the same four circuits; they are not eight separate switched outputs.
This Kit A version is the black four-switch assembly. It makes sense when LO-JPS01 is the correct switch configuration for the Jeep and you need four auxiliary controls. The system is rated for 12 volts, up to 800 watts total, and the relay/fuse box carries an IP66 rating. No ECU programming or dealer activation is required after installation.
What it will not do: LASFIT states that LO-JPS01 is not compatible with manual-transmission vehicles. It also is not the correct expansion kit for every factory switch configuration. If the Jeep already has the factory Mopar black AUX switch bank, LASFIT directs that application to a different expansion kit. If you are planning a full eight-switch LASFIT setup on a Jeep with no factory auxiliary bank, LASFIT recommends the appropriate full-kit combination rather than assuming Kit A alone provides eight circuits.
Manufacturer Specifications
- Model: LO-JPS01
- Kit configuration: Kit A, black four-switch auxiliary panel
- Accessory controls: 4
- System voltage: 12 V
- Relay/fuse circuits: four 30 A circuits
- Total output rating: 800 watts
- Output connection locations: cabin and engine compartment
- Relay/fuse box protection rating: IP66
- Dealer software update / ECU flash: not required
Fitment and Configuration
- Designed for compatible Jeep Wrangler JL and Jeep Gladiator JT applications
- Not compatible with manual-transmission vehicles
- Verify exact model year, transmission and existing factory switch-bank configuration before purchase
- Use the LASFIT kit specified for the Jeep's existing switch layout when adding or expanding auxiliary controls
Where this fits in the build
Vehicle-specific and open-air equipment should be chosen around fitment, environment, placement and the output needed where the system will actually be used.
Condition Notice
Closeout, Open-Box, Display, B-Stock or Used Item
This listing may have limited quantity, cosmetic wear, damaged or missing retail packaging, previous display use, open-box status, B-stock status, or another condition noted on the product page. Review the exact listing description and included accessories before purchasing.